MASTERCHEM INDUSTRIES INC -- KILZ AEROSOL, 51652-10004-4 -- 8010-00N026974 
=====================  Product Identification  =====================

Product ID:KILZ AEROSOL, 51652-10004-4
MSDS Date:07/03/1995
FSC:8010
NIIN:00N026974
=== Responsible Party ===
Company Name:MASTERCHEM INDUSTRIES INC
Address:3135 HIGHWAY M
Box:368
City:BERNHART
State:MO
ZIP:63012
Country:US
Info Phone Num:800-325-3552; 314-426-4227
Emergency Phone Num:800-325-3552;800-424-9300(CHEMTREC)
Preparer's Name:WILLIAM BENTON
CAGE:HO670
=== Contractor Identification ===
Company Name:CALDWELL PAINT MFG CO,INC DBA/MASTERCHEM INDUS
Address:3135 HIGHWAY M
Box:2666
City:ANTONIA
State:MO
ZIP:63012
Country:US
Phone:800-325-3552
CAGE:CALDW
Company Name:MASTERCHEM INDUSTRIES INC
Address:3135 HIGHWAY M
Box:368
City:BARNHART
State:MO
ZIP:63012
Country:US
Phone:800-325-3552/800-228-5635
CAGE:HO670

=============  Composition/Information on Ingredients  =============

Ingred Name:ACETONE (SARA 313) (CERCLA)  VP 185 @ 20C
CAS:67-64-1
RTECS #:AL3150000
Fraction by Wt: 15.50%
OSHA PEL:1000 PPM
ACGIH TLV:750 PPM; 1000 STEL
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:PROPANE, 1-NITRO-; (1-NITROPROPANE)  VP: 13 @ 20C
CAS:108-03-2
RTECS #:TZ5075000
Fraction by Wt: 0.90%
OSHA PEL:25 PPM
ACGIH TLV:25 PPM

Ingred Name:ETHANE, NITRO-; (NITROETHANE)  VP: 15.6 @ 20C
CAS:79-24-3
RTECS #:KI5600000
Fraction by Wt: 2.09%
OSHA PEL:100 PPM
ACGIH TLV:100 PPM

Ingred Name:ALKYD RESIN
CAS:71243-64-5
Fraction by Wt: 10-25%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS:13463-67-7
RTECS #:XR2275000
Fraction by Wt: 10-25%
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST

Ingred Name:VM & P NAPHTHA; (ALIPHATIC HYDROCARBON)  VP: 15 @ 37.7C
CAS:64742-89-8
Fraction by Wt: 17.18%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:HYDROCARBON PROPELLANT (PROPANE/ISOBUTANE); (PROPELLANT
    (PROPANE/BUTANE/ISOBUTANE BLEND))  VP: 70 PSIG @ 25C
CAS:68476-86-8
Fraction by Wt: 24%
OSHA PEL:N/K 
ACGIH TLV:N/K 

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:INHALATION: IRRITATION OF THE
    RESPIRATORY TRACT OR ACUTE NERVOUS SYSTEM DEPRESSION CHARACTERIZED
    BY THE FOLLOWING PROGRESSIVE STOPS: HEADACHE, DIZZINESS, STAGGERING
    GAIT, CONFUSION, UNCONSCIOUSNESS OR  COMA. SKIN OR EYE CONTACT:
    PRIMARY IRRITANT. REPORTS HAVE ASSOCIATED REPEATED AND PROLONGED
    (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: OCCUPATIONAL OVEREXPOSURE TO SOLVENTS
    WITH PERMANENT BRAIN AND NERVOUS SYSTEM DAMAGE. INTENTIONAL MISUSE
    BY DELIBERATELY CONCENTRATING AND INHALING THE CONTENTS MAY BE
    HARMFUL OR FATAL.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:INHAL: REMOVE TO FRESH AIR. RESTORE BRTHG. TREAT
    SYMPTOMATICALLY. CONSULT MD. EYES: FLUSH IMMED W/LARGE AMTS OF
    WATER FOR AT LEAST 15 MIN. TAKE TO MD FOR MED TREATMENT. SKIN: WASH
    AFFECTED AREAS W/SOA P & WATER. REMOVE CONTAMD CLTHG. CONSULT MD IF
    IRRIT PERSISTS. INGEST: DRINK 1 OR 2 GLASSES OF WATER TO DILUTE. DO
    NOT INDUCE VOMIT. CONSULT MD OR POIS CTL CTR IMMED. TREAT
    SYMPTOMATICALLY.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:-156F,-104C
Lower Limits:1.8%
Extinguishing Media:DRY CHEMICAL, FOAM, CARBON DIOXIDE.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
    EQUIPMENT .
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT, ELEC EQUIP, SPKS &
    OPEN FLAME. CLSD CNTNRS MAY EXPLODE WHEN EXPOS TO EXTREME HEAT.
    DURING EMER CNDTNS, OVEREXP TO COMBUST PRODS MAY (SUPDAT)

==================  Accidental Release Measures  ==================

Spill Release Procedures:LIMIT SPREAD OF SPILL OR LEAK. REMOVE ALL
    SOURCES OF IGNITION. SOAK UP WITH INERT ABSORBENT MATERIAL. USE
    NON-SPARKING TOOLS WHEN REMOVING WET ABSORBENT. SEE SECTION ON
    HNDLG & USE FOR REQD PROT MEASU RES. KEEP MATERIALS OUT OF SEWERS
    &/OR DRAINS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE AWAY FROM EXTREME HEAT/FIRE/OPEN
    FLAME. STORE I/A/W OSHA 1910.106, IN WELL VENTD AREAS & AS LEVEL 3
    AEROSOL (NFPA 30B). DO NOT TAKE INTERNALLY.
Other Precautions:AVOID PRLNGD CONTACT W/SKIN. KEEP CLOSURE TIGHT &
    CNTNR UPRIGHT TO PVNT LEAK. DO NOT STORE NEAR HEAT, SPKS OR OPEN
    FLAME. DRUMS OF MATL SHOULD BE GROUNDED & BONDED WHEN POURING.
    CNTNRS MUST NOT BE WAS HED OUT/USED FOR OTHER PURPOSES.(SUPDAT)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF YOU EXPERIENCE EYE WATERING, HEADACHES OR
    DIZZINESS, INCREASE FRESH AIR OR WEAR NIOSH APPROVED RESPIRATORY
    PROTECTION (TC 23C OR EQUIVALENT) OR LEAVE THE AREA.
Ventilation:VENT OF SUFFICIENT VOL & PATTERN SHOULD BE PROVIDED TO KEEP
    AIR CONTAMINANT CONCS BELOW LISTED OCCUP EXPOS LIMITS.
Protective Gloves:RUBBER OR NEOPRENE GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
    WEAR PROTECTIVE CLOTHING. REMOVE & WASH CONTAMINATED CLOTHING.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING THE WASHROOM.
    SMOKE IN SMOKING AREAS ONLY.
Supplemental Safety and Health
EXPLO HAZ: CAUSE HLTH HAZ. SYMPS MAY NOT BE IMMED APPARENT. OBTAIN MED
    ATTN. VAPS MAY BE IGNITED BY STATIC ELEC/FRICTION SPKS. OTHER
    PRECS: AVOID CNTCT W/OR BRTHG OF VAPS RELSD DURING CURING PROCESS. 
    NEVER USE WELDING/CUTTING TORCH ON/NEARDRUM (EVEN EMPTY) BECAUSE
    PROD (EVEN JUST RESIDUE) CAN IGNITE EXPLOSIVELY.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:>-44F,>-42C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Volatile Org Content %:60
Spec Gravity:0.982 
Evaporation Rate & Reference:FASTER/BUTYL ACETATE
Appearance and Odor:WHITE, AEROSOL SPRAY; MILD, SWEET KETONE ODOR.
Percent Volatiles by Volume:60

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRODUCE FUMES WHEN HEATED TO
    DECOMP AS IN WELDING OR FIRE. FUMES MAY CONTAIN: CO, CO*2 & OTHER
    PRODS OF COMBUSTION.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF I/A/W ALL LOC, STATE & FED REGS. DRY
    PRIMER & EMPTY AEROSOL CNTNRS MAY BE LANDFILLED. FULL OR PARTIALLY
    FULL AEROSOL CNTNRS SHOULD NOT BE PUNCTURED OR INCINERATED & SHOULD
    BE TREATED AS HAZ  WASTE WHICH REQS DISP AT APPRVD HAZ WASTE SITE.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.