THE SHERWIN WILLIAMS COMPANY, SPECIALTY DIVISION -- KRYLON INT/EXT ENAMEL (SEE SUPPLEMENTAL)  -- -
<pre>=====================  Product Identification  =====================

Product ID:KRYLON INT/EXT ENAMEL (SEE SUPPLEMENTAL)
MSDS Date:04/10/1989
FSC:NIIN:Submitter:D DG
Status Code:A
=== Responsible Party ===
Company Name:THE SHERWIN WILLIAMS COMPANY, SPECIALTY DIVISION
Address:6830 COCHRAN RD
City:SOLON
State:OH
ZIP:44139-3908
Country:US
Info Phone Num:216-292-7400
Emergency Phone Num:216-292-7400
Preparer's Name:NOT PROVIDED
CAGE:TO534
=== Contractor Identification ===
Company Name:NASCO INTL INC., NASCO DIV
Address:901 JANESVILL AVE
Box:City:FORT ATKINSON
State:WI
ZIP:53538-0901
Country:US
Phone:920-563-2446
Contract Num:MDA414-00-P-1788
CAGE:33089
Company Name:NASCO INTL INC., NASCO DIV
Address:901 JANESVILL AVE
Box:City:FORT ATKINSON
State:WI
ZIP:53538-0901
Country:US
Phone:920-563-2446
Contract Num:MDA414-00-T-0001-0424
CAGE:33089
Company Name:THE SHERWIN WILLIAMS COMPANY, SPECIALTY DIVISION
Address:6830 COCHRAN RD
Box:City:SOLON
State:OH
ZIP:44139-3908
Country:US
Phone:216-292-7400
CAGE:TO534

=============  Composition/Information on Ingredients  =============

Ingred Name:ACETONE
CAS:67-64-1
RTECS #:AL3150000
Minumum % Wt:30.
Maxumum % Wt:50.
OSHA PEL:2400 MG/M3;1000 PPM
ACGIH TLV:1780 MG/M3;750 PPM
ACGIH STEL:2380 MG/M3;1000 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:PROPANE
CAS:74-98-6
RTECS #:TX2275000
Minumum % Wt:10.
Maxumum % Wt:30.
OSHA PEL:1800 MG/M3;1000 PPM

Ingred Name:TOLUENE
CAS:108-88-3
RTECS #:XS5250000
Minumum % Wt:1.
Maxumum % Wt:5.
OSHA PEL:200 PPM
ACGIH TLV:188 MG/M3;50 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:XYLENE
CAS:1330-20-7
RTECS #:ZE2100000
Minumum % Wt:10.
Maxumum % Wt:30.
ACGIH TLV:434 MG/M3;100 PPM
ACGIH STEL:651 MG/M3;150 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:1-BUTANOL
CAS:71-36-3
RTECS #:EO1400000
Minumum % Wt:1.
Maxumum % Wt:5.
OSHA PEL:300 MG/M3;100 PPM
ACGIH STEL:C152 MG/M3;C50 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:METHYL ETHYL KETONE
CAS:78-93-3
RTECS #:EL6475000
Minumum % Wt:5.
Maxumum % Wt:10.
OSHA PEL:590 MG/M3;200 PPM
ACGIH TLV:590 MG/M3;200 PPM
ACGIH STEL:885 MG/M3;300 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:METHYL ISOBUTYL KETONE
CAS:108-10-1
RTECS #:SA9275000
Minumum % Wt:1.
Maxumum % Wt:5.
OSHA PEL:410 MG/M3;100 PPM
ACGIH TLV:205 MG/M3;50 PPM
ACGIH STEL:307 MG/M3;75 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:2-PROPANOL, 1-METHOXY-, ACETATE
CAS:108-65-6
RTECS #:AI8925000
Minumum % Wt:5.
Maxumum % Wt:10.

=====================  Hazards Identification  =====================

Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:SKIN ABSORPTION: NO HAZARDS KNOWN TO
    BORDEN. INGESTION: NOT EXPECTED TO BE HARMFUL UNDER NORMAL
    CONDITIONS OF USE. IF ACCIDENTALLY SWALLOWED, BURNS OR IRRITATION
    TO MUCOUS MEMBRANES, ESOPHAGUS OR GI T RACT CAN RESULT. INHALATION:
    MAY BE HARMFUL IF INHALED. LIQUID OR VAPOR CAN CAUSE IRRITATION OF
    NOSE, THROAT & LUNGS. CAN CAUSE CENTRAL NERVOUS SYSTEM DEPRESSION.
    SKIN: CAUSES IRRITATION. EYES: CAUSES  IRRITATION.
Explanation of Carcinogenicity:AS OF THE DATE OF ISSUANCE OF THIS
    DOCUMENT, THIS MATERIAL HAS NOT BEEN LISTED BY NTP, IARC OR OSHA AS
    A CARCINOGEN.
Effects of Overexposure:ACETONE: SYMPTOMS MAY INCLUDE HEADACHE,
    DIZZINESS NAUSEA, VOMITING, UNCONSCIOUSNESS AND EVEN ASPHYXIATION.
    1-BUTANOL: SIGNS & SYMPTOMS MAY INCLUDE HEADACHE, DIZZINESS,
    NAUSEA, VOMITING, UNCONSCIOUSNES S & EVEN ASPHYXIATION. PROPANE:
    CYANOSIS, RESPIRATORY DISTRESS, HEADACHE, DIZZINESS, DROWSINESS,
    UNCONSCIOUSNESS & ASPHYXIATION. METHYL ETHYL KETONE: MAY INCLUDE
    HEADACHE, DIZZINESS, NAUSEA, VOMITING,  UNCONSCIOUSNESS &
    ASPHYXIATION. METHYL ISOBUTYL KETONE: MAY INCLUDE HEADACHE,
    DIZZINESS, NAUSEA, VOMITING, UNCONSCIOUSNESS & EVEN ASPHYXIATION.
    TOLUENE: MAY INCLUDE HEADACHE, DIZZINESS, NAUSEA, VOMIT ING,
    UNCONSCIOUSNESS & ASPHYXIATION.

=======================  First Aid Measures  =======================

First Aid:INGESTION: DILUTE BY DRINKING LARGE QUANTITIES OF WATER.
    IMMEDIATELY CONTACT POISON CONTROL CENTER OR HOSPITAL EMERGENCY
    ROOM FOR ADDITIONAL TREATMENT. INHALATION: REMOVE TO FRESH AIR. IF
    NOT BREATHIN G, GIVE ARTIFICIAL RESPIRATION, PREFERABLY
    MOUTH-TO-MOUTH. SKIN: FLUSH WITH PLENTY OF WATER. REMOVE
    CONTAMINATED CLOTHING. CALL A PHYSICIAN IF IRRITATION PERSISTS.
    EYES: IMMEDIATELY FLUSH EYES WITH PL ENTY OF WATER FOR AT LEAST 15
    MINUTES. EYELIDS SHOULD BE HELD APART DURINGIRRIGATION TO INSURE
    WATER CONTACT WITH ENTIRE SURFACE OF EYES & LIDS. CALL A PHYSICIAN.

=====================  Fire Fighting Measures  =====================

Flash Point:AEROSOL CAN
Extinguishing Media:IN CASE OF FIRE USE DRY CHEMICAL, FOAM OR CO2.
    WATER MAY BE INEEEFCTIVE BUT SHOULD BE USED TO KEEP FIRE-EXPOSED
    CONTAINERS COOL.
Fire Fighting Procedures:DO NOT INCINERATE (BURN) CONTAINER. AVOID
    HEAT. KEEP CONTAINER BELOW 120F. HIGH TEMPERATURES MAY CAUSE
    BURSTING. DO NOT PLACE CONTAINER ON RADIATOR, STOVE, IN DIRECT
    SUNLIGHT OR NEAR OTHER HEAT SOURCE . DO NOT PUNCTURE CONTAINER.
Unusual Fire/Explosion Hazard:CONTENTS UNDER PRESSURE. WILL DISCHARGE.
    AVOID OPEN FLAMES, SPARKS, PILOT LIGHTS. DO NOT SMOKE. VAPOR MAY
    IGNITE EXPLOSIVELY. SPRAY MISTS OR VAPOR EVAPORATING FROM A
    DEFROSTED FILM IS HEAVIER THAN AIR	& MAY SETTLE IN LOW PLACES OR
    TRAVEL OUTWARD TO A SOURCE OF OGNITION & FLASH BACK.

==================  Accidental Release Measures  ==================

Spill Release Procedures:ELIMINATE ALL IGNITIOIN SOURCES. SOAK UP WITH
    ABSORBENT MATERIAL & REMOVE TO A CHEMICAL DISPOSAL AREA. PREVENT
    ENTRY INTO BODIES OF WATER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORAGE-DO NOT STORE AT TEMPERATURES
    OVER 120F. HANDLING-AVOID BREATHING VAPOR OR MIST. USE WITH
    ADEQUATE VENTILATION. AVOID CONTACT WITH SKIN. AVOID CONTACT WITH
    EYES.
Other Precautions:HANDLE IN ACCORDANCE WITH GOOD INDUSTRIAL HYGIENE &
    SAFETY PRACTICES WHICH INCLUDE AVOIDING UNNECESSARY EXPOSURE &
    REMOVAL FROM EYES, SKIN & CLOTHING. WASH THOROUGHLY AFTER HANDLING.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:WHERE AIR CONTAMINANTS CAN EXCEED CRITERIA, USE
    NIOSH-MSHA APPROVED RESPIRATORY PROTECTION EQUIPMENT. RESPIRATORS
    SHOULD BE SELECTED BASED ON THE FORM & CONCENTRATION OF
    CONTAMINANTS IN AIR IN ACCORDA NCE WITH OSHA 29 CFR 1910.134 OR
    OTHER APPLICABLE STANDRADS OR GUIDELINES.
Ventilation:LOCAL EXHAUST, ENCLOSED SYSTEM DESIGN, REMOTE CONTROL ALONG
    WITH PPE ARE OPTIONS
Protective Gloves:WEAR IMPERVIOUS GLOVES AS REQUIRED TO PREVENT SKIN
    CONTACT.
Eye Protection:GOGGLES IF CONTACT IS LIKELY.
Supplemental Safety and Health
NASCO: CONTRACTOR'S PART NUMBER: 97-14406(F) PAINT, KRYLON 12 OZ CAN
    SPRAY ENAMEL ULTRA FLAT BLACK.

==================  Physical/Chemical Properties  ==================

HCC:V3
Solubility in Water:SLIGHT
Appearance and Odor:NOT PROVIDED. PRODUCT IN AEROSOL CAN
Percent Volatiles by Volume:87-89 BY VOL

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
Hazardous Decomposition Products:OXIDES OF CARBON
Conditions to Avoid Polymerization:WIIL NOT OCCUR.

=====================  Ecological Information  =====================

Ecological:NOT PROVIDED

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE &
    FEDERAL REGULATIONS. EMPTY CONTAINER MAY CONTAIN EXPLOSIVE VAPORS.
    DO NOT CUT, PUNCTURE OR WELD NEARBY. INCINERATION WILL CAUSE
    CONTAINER TO BURST VIOLENTL Y.

===================  MSDS Transport Information  ===================

Transport Information:DOT CLASSIFICATION: ORM-D CONSUMER COMMODITY.

=====================  Regulatory Information  =====================

SARA Title III Information:SECTION 313: ACETONE, 36.71%; N-BITYL
    ALCOHOL, 1.00%; METHYL ETHYL ALCOHOL, 8.34%; METHYL ISOBURTL
    KETONE, 1.00%; 2-PROPANOL 1-METHOXY, ACETATE, 7.51%; TOLUENE, 1.63;
    XYLENE (MIXED ISOMERS), 10.66%.
Federal Regulatory Information:THIS MATERIAL IS A "HEALTH HAZARD"
    AND/OR "PHYSICAL HAZARD" AS DETERMINED WHEN REVIEWED ACCORDING TO
    THE REQUIREMENTS OF THE OCCUPATIONAL SAFETY AND HEALTH
    ADMINISTRATION 29 CFR PART 1910.1200 "HAZARD  COMMUNICATIO"N
    STANDARD.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.